Interlogix DVR 60 User Manual - Manual (Page 26)

2BChapter 3: Getting started
20 TruVision DVR 60 User Manual
Any changes you make to a setup configuration screen are saved when you exit
the screen and return to the main eZ Setup screen.
Note:
The TVR 60 firmware supports over 16 languages.
Figure 8: Setup Wizard screen
To quickly set up the TVR 60:
1. Connect all the devices required to the rear panel of the TVR 60. See
Figure 1 on page 7.
2. Turn on the unit using the power switch on the rear panel. After the boot up
screen, the TVR 60 displays video images on-screen.
3. Select the preferred language for the system.
4. In the eZ Setup screen, click
Next
. The User Permission screen appears.
5. Administrator configuration:
Navigate to the Admin Password edit box and click the edit box with the
mouse, or press Enter on the front panel or remote control, to display the
virtual keyboard. Enter the default admin password, 1234.
Note:
You must enter an admin password.
Caution
: It is strongly recommended that you change the password of the
administrator. Do not leave 1234 as the default password. Write it down in a
safe place so that you do not forget it.
Click
Next
. You are then asked if you want to enter the HDD Management
screen.
6. HDD management:
Click Enter to open the HDD Management screen and configure your HDD
settings as required.