Interlogix DVR 60 User Manual - Manual (Page 120)

14BChapter 15: HDD management
114 TruVision DVR 60 User Manual
To set up a HDD group:
1. Enter the HDD Management screen by clicking System in the main menu,
and then Hard Disk .
2. Select the HDDs to be added to the group.
3. Click
Group
to enter Group Settings screen.
4. Select the HDD Group Number 2.
Note: By default, all HDDs belong to group 1.
5. Click
OK
to save and exit the screen.
Setting the HDD status
You can change the behavior of your HDD by changing its status. The status of a
HDD can be set to redundancy, read-only or read/write (R/W).
Setting the HDD to read-only
A HDD can be set to read-only to avoid important recorded files from being
overwritten when the HDD becomes full.
To set a HDD to read-only:
1. Enter the HDD Management screen by clicking
System
in the main menu,
and then
Hard Disk
.
2. Click the General tab.
3. Select the HDD to want to set to read-only.
4. Click
Mode
. The Mode screen displays.