Ptz dome camera set up – Interlogix DVR 60 User Manual User Manual
Page 14
1BChapter 2: Installation
8
TruVision DVR 60 User Manual
Supported cameras
Resolutions
supported
Maximum bit rate -
Main stream
Maximum bit rate
- Sub stream
UltraView IP PTZ camera
4CIF, 2CIF, CIF, QCIF 1.7Mbps
1Mbps
CamPlus2 IP camera
VGA, QVGA
2Mbps
N/A
Panasonic IP camera
VGA, QVGA
2Mbps
N/A
PTZ dome camera set up
Use the USB mouse provided or the optional keypad for local telemetry control. If
using the TVR 60 over a network, use the web browser to control the PTZ dome
cameras or TruVision Navigator.
See Appendix C “PTZ protocols” on page 135 for the supported protocols.
Each PTZ camera must be set up individually. For information on configuring
PTZ dome camera settings, see Chapter 7 “Controlling a PTZ dome camera” on
page 47.
Connecting a TVR 60 to a PTZ dome camera and a
keypad
Use the input/output box that is supplied with the keypad to connect a keypad to
the TVR 60. The keypad can be connected to a PTZ camera for local control or
for control over the network.
See Figure 2 on page 9 for the preferred setup. Any PTZ dome camera can be
controlled as the DVR is doing the PTZ protocol translation. However, this setup
provides only limited dome configuration.