Interlogix DVR 60 User Manual - Manual (Page 32)

3BChapter 4: Operating instructions
26 TruVision DVR 60 User Manual
To use a USB mouse:
1. Plug USB mouse into one of the USB ports on the front or rear panel of the
DVR.
2. The mouse should automatically be detected.
See Table 5 below for a description of the mouse buttons.
Table 5: Mouse buttons
Item Description
Left button Single-Click : Select a component of a menu, such as a button or an input field. This
is similar to pressing the Enter button on the remote/front panel controls.
Double-Clic k: Switch between single screen and multi-screen mode in live/ playback
mode.
Click and Drag : Click and drag the left mouse button to setup the alarm areas.
Right button Single-Click : Shows pop-up menu
Scroll-wheel Scroll Up : In Live mode, scrolling up will switch to the previous screen. In Menu
mode, it will move the selection to the previous item.
Scroll Down : In live mode, scrolling down will switch to the next screen. In Menu
mode, it will move the selection to the next item
Using the IR remote control
The TVR 60 is supplied with an infra red (IR) remote control unit. Like the mouse,
it can be used to operate all of the main functions of the TVR 60.
The IR remote control can be programmed with a unique device ID address so
that the controller will only be able to communicate with DVRs with that address.
No programming is necessary if using a single TVR 60.
The device ID address only applies when using a remote control and not when
using a keypad.
You can purchase a remote control by ordering part number TVR-REMOTE-1
TruVision™ DVR Model 40/60 IR Remote Control.