Interlogix DVR 60 User Manual - Manual (Page 34)

3BChapter 4: Operating instructions
28 TruVision DVR 60 User Manual
Item Description
14. Tour Enter preprogrammed three-digit code to call up shadow tour.
15. Focus + and - Use to control focus of camera lens.
16. Playback control Use to control playback (Rewind, Pause, Play, and Fast Forward).
17. Search Open the Search menu.
18. Replay Replay the selected file from the beginning.
19. Eject Eject the CD or DVD disk.
20. Archive Press once to enter quick archive mode. Press twice to start archiving.
Aim the remote control at the IR receiver located at the front of the unit to test
operation.
To connect the remote control to the TVR 60:
1. Press the Menu button on the remote control or front panel or right-click the
mouse and select the Menu button. The main menu screen appears.
2. Click the
Display
icon.
3. Click the Monitor tab. The Monitor screen appears.
4. Check and remember the DVR device address value. The default value is
255. This device address is valid for all IR controls.
Note
: The device address does not apply to keypads.
5. On the remote control press the
Device
button.
6. Enter the device address value. It must be the same as that on the TVR 60.
7. Press the ENTER button on the remote or front panel.
To place batteries into the IR remote control:
1. Remove the battery cover.
2. Insert the batteries. Make sure that the positive (+) and negative (−) poles are
correctly placed.
3. Replace the battery cover.
Troubleshooting the remote control:
If the IR remote control is not functioning properly, perform the following tests:
• Check the battery polarity.
• Check the remaining charge in the batteries.
• Check that the IR remote control sensor is not masked.
If the problem still exists, please contact your administrator.