EVCO EVCSR818P9EF - Manual (Page 52)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 52 of 94
3. Press and release the key (2) or the key (3) to select the program number and then press and release the key
SET (6) in order to associate a name.
4. Press and release the key (2), the key (3), the key (5) or the key (4) to select the character and then press and
release the SET (6) key to confirm it.
5. Press and release the key (2), the key (3), the key (5) or the key (4) to select “[END]” and then press and
release the SET (6) key.
Operate as follows to abandon the procedure indicated:
6. Press and release the ESCAPE key or do not operate for 60 s.
7.3 Execution of a program
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key with icon open book (1)
Press and release the key (2) or the key (3) to select the program and then press and release the START/STOP key (4)
to start it: the operating cycle will be started with the settings memorised in the program.