EVCO EVCSR818P9EF - Manual (Page 44)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 44 of 94
6.12.1 Selecting the evaporator fan speed
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key (1), press and release the key (2),
and then press and release the key (3) or the key (4). The LED bars will supply information relative to fan speed (for
example, one bar corresponds to speed 1, two bars on correspond to speed 2, three bars on correspond to speed 3,
etc.).
Alternatively:
4. Make sure the device is in the "run" status.
5. Make sure that the keyboard is not locked and that no procedure is in progress.
6. Press and release the MENU key and then press and release the key (1) or the key (2) to select the evaporator
fan speed
7. Press and release the key + (3) or the key – (4) to modify these values and then press the ESCAPE key to
memorise it.