EVCO EVCSR818P9EF - Manual (Page 14)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 14 of 94
The RS-485 port is for the connection of the controller to the following additional products:
- Parameters Manager set-up software system
- Plant monitoring and supervision system via Internet: CLOUDEVOLUTION
- printing module PM 100A X9S001.
The port must not be used simultaneously with more than one of these products.
4.2 Warnings for the electric connection
- do not use electric or pneumatic screwdrivers on the device terminal board
- if the device has been taken from a cold to hot place, humidity could condense inside; wait about 1 hour before
powering it
- make sure that the power supply voltage, the frequency and the operational electric power of the device,
correspond with those of the local power supply; see chapter 16 "TECHNICAL DATA"
- disconnect the device power supply before proceeding with any type of maintenance
- do not use this device as a safety device
- for repairs and information regarding the device, contact the EVCO sales network.