EVCO EVCSR818P9EF - Manual (Page 47)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 47 of 94
5. Press and release the key light (2) and then press and release the START/STOP key (3)
The device will display the residual time of the UV light switch-on duration and the cabinet temperature.
The UV light is switched on for the time period established by parameter u6; opening the door i.e. the activation of the
door micro switch cause the light to switch off.
If the UV light is on, it will not be allowed to select or start any operating cycle.
6.16 Heating the needle probe
Operate as follows:
1. Make sure the device is in the "on" status or storage is in progress and that the door is open, i.e. the door
micro switch is active.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key (1), press and release the key (2) and then press and release the START/STOP key
(3).
The device will display the temperature detected by the needle probe and the cabinet temperature.