Toshiba LF434 - Manual (Page 90)

TOSHIBA
6 F 8 A 0 7 7 . 0
■ To change the enable/d[sable status of the tlxcd-value output and its output values:
The following example shows how to cnabk the fixcd^value oulput fonction and to set its
lixed current oulput to 20 mA DC,
Key operation ; Display example Description
SET
□ L1: FIXED 0UT
0FF
Press [SET] first To start the items selection sequence
and select LI: FIXED OUT from among the
configimitiori hems using [ ► ] and [ a . j keys, Then
press fSH'n again to display the current fixed-output
enable, disable status (OFF inthls example).
►
□
L1: FIXE0 0UT
0FF
Pressing [ ► ], the cursor appears
▲
□
L1: FIXED 0UT
0N
Select by pressing [ a . ].
SET
1 1 : FIX. CIJRR.
10, 0 líA
Pressing [SET), the selected status (ON) flickers. Press
[SETj again to save the status. Then the system goes to
the fixed current value setting sequence.
►
□
LZ: FIX. CURR.
10, 0 IBA
Move the cursor to the digit to be changed.
▲
□ L2: FIX. CURR.
20, 0 JiA
Change the value to
' '
2
' ’
by pressing [ a ] twice.
(If necessary, move the cursor to another digit by
pressing f ► 1 and change the value.) (Note 1)
SET L3: FIX. PULSE
100 PPS
Pressing [SET], the cursor disappears and the changed
value display flickers. Press [SEl] again to save the
value. Then The .system goes to the fixed pulse oulput
>cning sequence. (Note 2)
SET
□
L3: FIX. PULSE
100 PPS
Pressing [SE l ], the cursor disappears and the fixed
pulse output value flickers. Press [SET] again to save
ihe value.
SET
□
L3; FIX, PULSE
Pressing [SET], Ihe system returns to the items
selection sequence.
Notes:
L If you try to set the fixed-vaJue output above the allowable range, iui error message
t H. OVER SPEC appears. Try to set the value within the specified range,
2, if PUL^l' OUT is not selected for digital output, the subsequent pulse output selling
sequence w'ill not be displayed.
- 89 -