Toshiba LF434 - Manual (Page 10)

TOSHIBA
6 F 8 A 0 7 7 0
1, Product Inspection and Storage
i;pon arrival of The product piickfige» open [lie package and check the items contained inside,
If you do not intend to install the product soon after opening llie package, store the product
and other related items in a place such as described in 1.2 below,
IJ Product Inspection
The LE^34/LF404 electromagnetic flowmeter is shipped in a cardboard cnniaincr filled with
shock-ahsorbing materials. Open the package carefully and check as follows:
■ Make sure the following items are included in the package.
(1) Model LF434/LF404 Electromagnetic Flowmeter,.,.,, i
(2) Instruction Miitiual .............................................................. j
■ Inspect the flowmeter for indications of damage that may have occurred during shipment.
■ Make sure the type and spedficalions of the flowiiieter arc in accordance with the
ordered specifications,
If you cannot find the items listed above or any problem e?(ists, contact your nearest
I’oshiba representative,
1,2 Storage
To store the LF434/LF404 flowmeter after opening the package, select a
storing place as follows and keep it under the conditions described below;
(1) Avoid places where there is direct sunlight, rain or wind.
(2) Store the product in a wcll-veniilated place. Avoid places of extremely high
humidity or extremely high or low temperature. The following cnvlroiitucnt is
recommended;
« Humidity range: 10 to 9i)% RH [no candensation)
• Storage temperature: -15 to +65* C
(2) Avoid places where vihralions or mechanical shock occur.
(4) Do not leave the converter housing cover open . Open the cover only w-hen
you actually start wiring cables. Leaving the cover open catt cause gradual
dctcrioraiion of circuit isolation,
(3) To pm the flowmeter temporarily on the floor, place it carefully with something
to support it so that the flowmeter will not topple over
-
9
-