Toshiba LF434 - Manual (Page 65)

TOSHIBA
6 F 8 A 0 7 7 0
To change the hysteresis:
The hysteresis is set ai /!% (default) when shipped from the factory.
The following example shows how' to change the hysteresis from 1 > % to 5%.
Key operation Display example Dciscription
^ET
□
C i :
RANGE HY$T
03. 0
%
Press [SETj first to siart the items selection sequence
iind sd eel C6i RANGE HYST fro m a mo ng the
configuration items using [ ► J and [ a j keys. Then
press [SET] again to display the current hysteresis
( 3 . 0 % in this example).
►
CG: RANGE HYST
03, 0
%
Pressing [ ► ]* the cursor appears.
►
□ C6: RANGE HYST
oa. 0
%
Press [ ► ] to move the cursor to the desired digit to
change.
▲
□ CG: RANGE HYST
05. 0
%
Change the value to “5” by pressing [ ^ ] twice.
(if necessary, move the cursor to another digit and
change the value).(Note)
SET
CG: RANGE HYST
05. D
%
Pressing fSET], the cursor disappears and the
changed display flickers. Press [SE'll again to store
the changed iwsteresis.
SET
□
CG: RANGE HYST Pressing [SET], the system returns to the item selec­
tion sequence.
Note: if you try to set the hysteresis above 25.0 %,an error message H. OVER SPEC.'
appears. Try again to set the value within the specified range.
- 64 -