Toshiba LF434 - Manual (Page 16)

TOSHIBA
6 F 8 A 0 7 7 . 0
4.1 Location
['ey
fielect the inslallatioi] site, follow the precautions described below:
■ Avoid places where fluid runs in a pulsating form.
■ Avoid places within the immediaic proximity of equipment producing declricul
inleгf^^rencc (such as motors, transformers, radio irunsmittcrs, electrolytic ceils, or
other equipment causing electromagitclic or electrostatic interference),
■ Avoid places where excessive pipe vibration occurs.
■ Avoid places where there is direct sunlight. !f this is unavoidable, use an appropriate
shade
■ Avoid places where corrosive atmospheres or high humidity conditions obtain,
■ Avoid places of too great an elevation or constricted areas where clearance
for installation or maintenance work is not provided,
■ Design piping so that the dcicetor pipe is always filled with fluid, whether the Quid is
flowing or not,
■ The LF434 detector has no adjustable piping mechanism. Install an adjustable short
pipe w'here needed.
■ Chemical injections should be conducted on the downstream side of the flowmeter.
- 1 5 -