Toshiba LF434 - Manual (Page 81)

TOSHIBA
6 F 8 A 0 7 7 0
To change the high/lo>v [imit value:
The following example shows how to change the high limit value from +1U5 % lo -t-103
Key u pera cion Uisplity example Description
SET
□ [2; K ALARM VAL
+105. 0ÍÍ
Press [SETj first ro start the items selection sequence
ind select \ 2 : ALARM VALfrom among the con­
figuration items using [ ► J and [- a . j keys. Then
press [Sl'/f] again to display the current high limit
value (+105.0% in this example).
►
□ [2; H. ALARM VAL
+105. Q %
Pressing [ ► ], the cursor appears. Then press [ ^ 1
many times as necessary to move the cursor to the digit
:o lx: changed.
□
12: K ALARM VAL
+ 103. Ú %
Change the value lo “3” by pressing [ ^ 1 as many limes
as necessary. (Note)
(If necessary, move the cursor to another digit by-
pressing \ ► ] and change Ihe value.)
SET
□
12: H. ALARM VAL
+ 103. Ü %
Pressing [SH I ], the cursor disappears and the changed
high limit value display flickers, Press fSE'I'] again to
save the value,
SET
□
12: H. ALARM VAL Pressing [SET], the system returns to ihe items selcc-
lion sequence.
Note: If you try to Ihe value above +110% or below -10% of the span, the error mes­
sages *H OVER SPEC or *L OVER SPEC, respectively appear. Set the high limit
value within the specified range.
-
80
-