Safety precautions for maintenance and inspection, Disclaimer, Caution – Toshiba LF434 User Manual
Page 5: Toshiba
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TOSHIBA
6 F 8 A 0 7 7 0 :
SAFETY PRECAUTIONS (contiaued)
Safety Precautions for Maintenance and Inspection
âs
CAUTION
■ Turn off mains power before
conducting wiring work.
Wiring while power is ap-
plied can cause electric shock,
DO
■
Ground (he LF434/LF404 indepen
dently from power equipment.
Operating this product without
grounding can cause electric
PQ shock or malfunction.
■ Do not conduct wiring work with bare
hands.
Rcma i n i n g cJ cetr ic charge
(
even if pov-'cr is turned off
^
can still cause electric shock.
DONT
■ Use compression terminal lugs with
insulation sleeve for the terminal
block and GND terminal.
1.0QSC connections can cause
electric shock, fire from
excessive current or system
malfunction.
■
Do not work on piping and wiring with
wet hands.
Wet hands may result in
f
electric shock,
DON'T
The label shown left is placed
near the terminal board for
power input.
/
i \ (A black border and symbol on
yellow triangle)
Be alert to electric shock.
■
Do not touch the flowmeter main
body when high temperature fluid is
being measured.
The fluid raises the main
i
body temperature and can
^
cause bums when touched.
DON’T
■
Do not conduct wiring work when
power is applied.
Wiring while power is applied
I
can cause electric shock,
DONT
■ Do not conduct wiring work with wet
hands.
1^0
Wet hands may result in
elccrric shock.
DONT
1
be label shown left is placed
* near the terminal board for
power inp ut.
\
(A black border and symbol on
yellow triangle)
Be alert to electric shock.
■ Do not use a fuse other than the one
specified.
Using a fuse other than the
j one specified can cause
j/
system failure, damage or
malfunction,
DONT
Use a rated fuse as follows:
Fuse rating:
^ lA/^.'inV for lilt) to 240Vac or
1 liiVdc
* 2A/2.^0V for 24 Vdc
Dimensions:
Diameter
5.2
mm x 20 mm
Melting time characteristic:
Normal blow j
Disclaimer
Toshiba does not accept liability for jny damage or loss, material or personal, caused as a
direct or indirect result of the operation of this product jii connection with, or duo to, llie
occurrence of any event of force majenre (including fire or earthquake) or the misuse of
this product, whether inicnclonal or accidentaL
-
4
-