Toshiba LF434 - Manual (Page 57)

TOSHIBA
6 F 8 A 0 7 7 0
I To chimge the indicating unit (2):
Only in case of ihc converter for special specifications (refer to 7J.3 "Converter for
Special spedfications"). Code of volumetric flow direction h’(fixcd forward flow),
R(fixed reverse flow), H(automatic selection bi-directional flow) can be selected.
In ease of normal converter, the code of volumetric flow direction does not appear.
The following example shows how' to change the primary indicating unit from F to R.
Key operation Display example IJe.scription
SET
□ Bl: U N I T 1
n' F
Press [SET] first to start the items selection sec|uencc
:o select Bl: UNIT 1 from among the configuration
items using [ ► ] and [ a . j keys Then press [SET]
again to display the current primary indicating unit (m^
F in this example).
►
□
Bit J N I T 1
F
Pressirtg [ ► ], the cursor appears.
►
□
B1: J N I T 1
m* F
Pressing [ ► ], the cursor moves to the second unit
dime unit) of primary indicating unit.
►
□
B1 : U N I T 1
n' F
Pressing [ ► ], the cursor moves to the third unit
(code of volumetric flow direction) of primary
Liidicaiing unit.
▲
□ Bl: U N I T 1
R
Select *‘R” as the third unit (code of volumetric flow
direction) of primary indicating unit by pressing [
a ]
as many limes as necessary. (Note 1)
SET
□
Б1: U N I T 1
I t ' R
Pressing [SET], the cursor disappears and the changed
display flickers. Press [SliT'J again to save the miit.
SET □ Bl: U N I T 1 Pressing [SET], the system returns to the item
selection .sequence.
Notes. The third u n i t (code of volimetric flow direction) changes as shown below:
B ------- ► F ---------► R -------
-
5 6
-