BUCHI PrepChrom C-700 - Manual (Page 59)

BÜCHI Labortechnik AG Installation | 5
PrepChrom C­700 59/110
Curves Show or hide the curves obtained/plat­
ted (= curves panel) on the method re­
port
Peak Tracking Show or hide the peak tracking picture
resulting from a method on its report
Collection Table Show or hide the collection table re­
sulting from a method on its report
Elution Steps Show or hide the elution steps of the
method executed on its final report
Detection Steps Show or hide the detection steps of the
method executed on its final report
Collection Steps Show or hide the collection steps of the
method executed on its final report
Plates Nb. Display or hide an additional column in
the collection table which gives the
number of plates for peaks obtained on
the chromatogram, these calculated
values appear only in Peak mode
Physical Units
Pressure Select the unit for pressure used
throughout the software
Max Pressure Select the unit for maximum pressure
used throughout the software
Volume Select the unit for the containers' vol­
umes used throughout the software
Injected Volume Select the unit for the injected volumes
used throughtout the software
Flow Rate Select the unit for flow rate used
throughout the software
Inject Flow Rate Select the unit for injection flow rate
throughout all the software
Weight Select the unit for column weight used
throughout the software
Injected Weight Select the unit for injected weight used
throughout the software
Height Select the unit for column bed height
used throughout the software
NOTE
Changes will be still active after a restart of the device.
u Press Save to store the settings.
u Press Ok to finish the user profile setup.