Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 78)

72 880 Technical/Service Manual
Setpoints Menu
Note
Table 6-16. Setpoints EDP Commands
Command Menu Description Choices / Range
SP.ACCESS#n ACCESS Setpoint access in top level menu (user) OFF, ON
SP.BANDVAL#n BNDVAL Band value 0 - 999999
SP.BRANCH#n BRANCH Branch destination 0,1-20
SP.CLRACCM#n CLRACM Clear accumulator OFF, ON
SP.CLRTAR#n CLRTAR Clear tare OFF, ON
SP.DIGOUT#n DIGOUT Lists all digital output bits available for the
specified SLOT NONE, BIT1 – BIT4
SP.END#n END Ending setpoint number for TIMER and CONCUR 1- 20
SP.HYSTER#n HYSTER Hysteresis Range:
0 - 65535 (for the COUNTR and
DELAY setpoints)
0 - 999999 (for the GROSS,
NET, and %REL setpoints)
SP.KIND#n Selection made
directly after
dropping down
from SETPT x Supported setpoint kinds OFF, GROSS, NET, -GROSS,
-NET, %REL, PAUSE, DELAY,
WAITSS, COUNTR, AUTJOG,
TIMER, CONCUR
SP.BATSEQ#n BATSEQ Specifies whether the setpoint is a batch step OFF, ON
SP.NAME#n NAME Setpoint name string Alphanumeric, Max Length: 6
SP.PCOUNT#n PCOUNT Preact learn interval (number of cycles before it
learns) Range: 0 - 65535
SP.PREACT#n PREACT Preact type OFF, ON, LEARN
SP.PREADJ#n PREADJ Preact adjustment percentage Range: 0 – 999999
SP.PRESTAB#n PRESTB Preact learn stability Range: 0 - 65535
SP.PREVAL#n PREVAL Preact value Range: 0 - 999999
SP.PSHACCM#n PSHACM Push accumulate OFF, ON, ONQUIET
SP.PSHPRINT#n PSHPRT Push print OFF, ON, WAITSS
SP.PSHTARE#n PSHTAR Push tare OFF, ON
SP.RELNUM#n RELNUM Relative setpoint number 1- 20
SP.SENSE#n SENSE Digital output sense NORMAL, INVERT
SP.DSLOT#n SLOT Digital output slot NONE, SLOT0, SLOT1
SP.START#n START Starting setpoint number for TIMER and CONCUR 1- 20
SP.TRIP#n TRIP Specifies when the setpoint is satisfied when
compared to value HIGHER, LOWER, INBAND,
OUTBAND
SP.VALUE#n VALUE Setpoint value Range:
0 - 65535 (for the COUNTR
and DELAY setpoints)
0 - 999999 (for the GROSS,
NET, and %REL setpoints)
BATCHNG BATCHG Batching enable OFF, AUTO, MANUAL
Note
For setpoint commands the “n” symbolizes the setpoint number, 1-20.
Different setpoint parameters are available and accepted depending on KIND, TRIP, and PREACT. These
restrictions are listed below by the EDP command name but the same applies to access by menu.