Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 14)

8 880 Technical/Service Manual
8. Press MENU to return to weighing mode.
Note
Some indicator configurations may not allow setpoints to be turned off through the front panel or may require
a password to turn the setpoint on and off.
1.4.11 Set Time and Date
1. Press MENU , AUDIT is displayed.
2. Press or until T&D is displayed.
3. Press , TIME is displayed.
4. Press , to enter time.
5. To edit the value:
• Press or to select the digit.
• Press or to increment or decrement the value.
6. Press TARE when the value is correct. DATE is displayed.
7. Press , to enter date.
8. To edit the value in specified format (MMDDYY, DDMMYY, or YYMMDD):
• Press or to select the digit.
• Press or to increment or decrement the value.
9. Press TARE when the value is correct. TIME is displayed.
10. Press MENU to return to weighing mode.
1.4.12 Display Accumulator
The accumulator must be enabled before use in either normal mode or setpoint operations. Once enabled, weight
(net weight if a tare is in the system) is accumulated whenever a print operation is performed using the
PRINT
key,
digital input, setpoint PSHACC operation or KPRINT serial command. The scale must return to below the
threshold value (except for the setpoint PSHACC operation) before the next accumulation.
1. Press MENU to enter the user setup mode, AUDIT is displayed.
2. Press or until ACCUM is displayed.
Note
Note ACCUM
is only displayed if the accumulator is enabled.
3. Press , VIEW is displayed.
4. Press to view the current accumulator value.
5. While the accumulator value is displayed, press PRINT to print the value.
The format of the print output can be configured using accumulator print format. See Section 7.0.
1.4.13 Clear the Accumulator
1. Press MENU to enter the user setup mode, AUDIT is displayed.
2. Press or until ACCUM is displayed.
3. Press , then press or until CLR Y is displayed.
4. Press TARE to clear the accumulator, CLEAR will display briefly and display returns to CLR Y .