Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 60)

54 880 Technical/Service Manual
3.2.14 Digital Input Menu
SETUP
.... ....
BIT 1 BIT 2-4
....
DIGIO
....
OFF
PRINT
ZERO
TARE
UNITS
CLEAR
DSPACC
DSPTAR
NT/GRS
CLRCN
BATRUN
BATSTR
BATPAS
BATRST
BATSTP
OUTPUT
SLOT 0
Same as
SLOT 0
BIT 1
Figure 3-22. Digital I/O Menu
DIGIO Menu
Parameter Choices Description
Level 2 submenus
SLOT 0 BIT 1 –
BIT 4 Select the bit to set the function of.
SLOT 0 submenu
BIT 1
BIT 2
BIT 3
BIT 4 OFF
PRINT
ZERO
TARE
UNITS
CLEAR
DSPACC
DSPTAR
NT/GRS
CLRCN
BATRUN
BATSTR
BATPAS
BATRST
BATSTP
OUTPUT Specifies the function activated by Bits 1–4.
• PRINT, ZERO, TARE, UNITS, NT/GRS provide the same functions as the five front panel
keys.
• DSPACC displays the current accumulator value.
• DSPTAR displays the tare.
• CLRCN resets the consecutive number to the value specified on the RESVAL parameter
(FEATUR menu).
• BATRUN allows a batch routine to be started and run. With BATRUN active (low), the
BATSTR input starts the batch; if BATRUN is inactive (high), BATSTR resets the batch.
• BATSTR starts or resets a batch routine, depending on the state of the BATRUN input.
• BATPAS pauses a batch routine while held active (low).
• BATRST resets a batch to first batch setpoint.
• BATSTP stops a batch at the current step.
• OUTPUT defines a bit as an output to be used by the setpoint.
Table 3-16. Digital I/O Menu Parameters