Rice Lake 880 Performance Series Indicator/Controller Technical/Service Manual - Manual (Page 12)

6 880 Technical/Service Manual
1.4.6 Preset Tare (Keyed Tare)
Note
Tare mode must be set to keyed or both for the preset tare feature to function.
1. With the scale empty and display showing zero weight, press TARE .
2. Display will show (000000); the focused digit will flash.
3. To edit the value:
• Press or to select the digit.
• Press or to increment or decrement the value.
• Press TARE to move to the decimal point entry.
• Press or to adjust the decimal point placement.
• Press TARE when the value is correct.
4. The display will change to the Net mode and the
PT
LED lights to show the preset tare was entered.
Note Entering a keyed tare of zero will remove the stored tare value.
1.4.7 Print Ticket
1. Wait for the ( ) LED to light.
2. Press PRINT to send data to a communications port.
1.4.8 Front Panel Setup
1. Press MENU to enter user setup mode. Use user setup to:
• View audit trail information
• Enter setup mode if audit trail is enabled
• View or set time and date
• View or clear the accumulator
• Change setpoint values and enable/disable setpoints
• View the current tare value
1.4.9 Displaying Audit Trail Information
The Audit Trail Configuration and Calibration counters can be viewed through the User Menu.
1. Press MENU , AUDIT is displayed.
2. Press to display the Legally Relevant Firmware version.
3. Press to display CALIB.
4. Press to view the Calibration Counter.
5. Press MENU to return to CALIB.
6. Press to display CFG.
7. Press to view the Configuration Counter.
8. Press MENU to return to CFG.
9. Press MENU to return to the weigh mode.