7 quick start: sync & share, 1 first run, Quick start: sync & share – Acronis Access Advanced - Installation Guide User Manual

Page 168: First run

168

7 Quick Start: Sync & Share

This guide provides the essential steps for setting up Sync & Share, using the web interface to access
files and using the Acronis Access desktop client. For more detailed instructions on configuring these
components, see the Sync & Share and Desktop Client sections.

In this section

First Run ................................................................................................. 168
Using the web interface to access files .................................................. 171
Using the desktop client ........................................................................ 177

7.1 First Run

If you haven't done so already, install and configure Acronis Access. For more information on doing
so, check the Installing (p. 5) and Configuration Utility (p. 9) sections.

When you first open the web interface, you will have to set a password for the default administrator
account and after you log in, you will be greeted by the Setup Wizard.

Warning! Please do not forget your administrator password as the support department cannot recover this
password for you

Note: It may take 30-45 seconds until the application becomes available after starting it from the Configuration
Utility.

Once you have completed the above, you are ready to go through the Initial Configuration described
below.

General Settings

1. Enter a Server Name.
2. Specify the root DNS name or IP address where users can access the website (starting with

http:// or https://).

3. Specify the DNS name or IP address to which the mobile users will enroll to.