Acronis Access Advanced - Installation Guide User Manual

Page 123

123

10. Enter the password for your postgres super-user and press Next.
11. When the installation finishes, press Exit to close the installer.

Warning! Do not bring the cluster group online!

12. Move the cluster group to the second node.
13. Complete the same installation procedure on the second node.
14. Bring all of the Acronis Access services online.

5 Upgrading from mobilEcho 4.5 on a Microsoft

Failover Cluster

Warning! Acronis Access failover clustering is not supported by versions older than 5.0.3. If you're using an
older version, you will have to upgrade to version 5.0.3 or newer before proceeding with any kind of cluster
configurations.

The guides listed below will help you upgrade your cluster from mobilEcho to Acronis Access.

In this section

Upgrading a mobilEcho server on a Windows 2003 Failover Cluster to Acronis Access

123

Upgrading a mobilEcho server on a Windows 2008 Failover Cluster to Acronis Access

132

Upgrading a mobilEcho server on a Windows 2012 Failover Cluster to Acronis Access

143

5.1 Upgrading a mobilEcho server on a Windows 2003

Failover Cluster to Acronis Access

1. Open the Cluster Administrator and double-click on your service group.
2. Delete the mobilEcho service resources.

Note: Do not bring the entire cluster group offline, just delete the mobilEcho service resources.

3. Launch the installer on the active node.
4. Disable any anti-virus software you have or it may interrupt the installation procedure resulting

in a failed installation.

5. Double-click on the installer executable.