Acronis Access Advanced - Installation Guide - Manual (Page 115)

115 Copyright © Acronis International GmbH, 2002-2014
Using the Configuration Utility
On the Gateway Server tab
1. For the Address field, enter the IP address of your server that was running mobilEcho. This is the
address you wrote down at the beginning.
2. For the Port field, enter the port number that your mobilEcho File Server used.
3. Add the certificate you have been using for the mobilEcho File Server.
On the Access Server
1. For the Address field, enter the IP address you've been using for your activEcho server until now.
This should be the default.
2. For the Port field, enter the port number you've been using for your activEcho server until now.
This should be the default.