Metrohm 785 DMP Titrino - Manual (Page 53)

2.12. TIP, Titration procedure
785 DMP Titrino
50
Information for the commands (steps):
Command Meaning Input range
method Method from the user memory or from the card. This
method runs as a submethod.
Name
pause Waiting time. The waiting time can be aborted with
.
sets "inf" (= infinitely long pause time).
0...999 999 s,
inf.
L4, L6 output Set L4 output (pin 3) resp. L6 output (pin 1) of the
remote socket.
active = 0 V, inactive = 5 V, pulse > 100 ms, off =
output is not used.
Cable Titrino (L6) - Dosimat: 6.2139.000.
Important: A pulse (e.g. a pulse from monitoring or an
activate pulse in a submethod) can set an active output
to inactive! At the end of the TIP method, the outputs
are set to "inactive".
active,
inactive,
pulse, off
info Message in the display .
The TIP sequence is held and the message displayed.
Continue the sequence with , or
.
up to 16
characters
stirrer Switching stirrer ON/OFF.
In TIP the stirrer is not switched automatically in the
submethods. At the end of TIP the stirrer is switched off
(if stirrer control is ON).
ON, OFF
The parameters of the sequence can be viewed and changed at any time under the
key.