Metrohm 785 DMP Titrino - Manual (Page 16)

2.5 Selection of the mode, key
785 DMP Titrino
13
2.5 Selection of the mode, key
Press key until the desired mode is
displayed and confirm with .
Select the measured quantity pH, U, Ipol, Upol, (T) with
< ← > or < → > and confirm it also with .
The following modes can be selected:
• DET: Dynamic Equivalence-point Titration
• MET: Monotonic Equivalence-point Titration
• SET: Set Endpoint Titration.
• CAL: pH Calibration.
• MEAS: Measuring.
• TIP: Titration Procedure. Linking of various
commands and methods to a titration procedure.
These standard modes are equipped with a set of
standard parameters. They only need few settings in
order to be ready to work.
TIP is an empty "shell". The TIP sequence has to be
defined with , see page 49.
You will find a survey of the modes in the short
Instructions for use, page 10.
MODE
;
–
mode
mode: DET
measured quantity: pH