Metrohm 785 DMP Titrino User Manual
Page 109
3.2. Remote control commands
785 DMP Titrino
106
.L4 Output: Warning: A pulse triggered by the limit value monitoring at L4 (pin
3) in a submethod sets an output set to active in TIP to inactive.
.L6 Output: Warning: An activate pulse at L6 output (pin 1) in a submethod
sets an output set to active in TIP to inactive.
.Info:
Entry of a message which is written into the display. The se-
quence remains in the display with the corresponding message.
Continue with &m $G.
.Stirrer:
Switching stirrer on/off.
3.2.2.49. Mode.Parameter.Presel.MeasMode
pH, U, Ipol, Upol, OFF
Mode.Parameter.Presel.MeasInput
1, 2, diff.
Mode.Parameter.Presel.Ipol
0...1...
±
127
Mode.Parameter.Presel.Upol
0...400...
±
1270
Mode.Parameter.Presel.PolElectrTest
ON, OFF
Mode.Parameter.Presel.Temp
-170....25.0...500.0
Parameters for TIP: Selection of the measured quantity for manual measure-
ments in the inactive state, see 3.2.2.2. Selection of the measuring input
(MeasInput) applies to measured quantities pH and U. "diff." means differen-
tial amplifier, see page 158. With Ipol the requests for the polarization current
in uA (Ipol) and .PolElectrTest apply. With Upol the request for the polarization
voltage in mV (Upol) applies. Entry in steps of 10 mV. .PolElectrTest also ap-
plies. If the test for polarized electrodes is switched on (ON), it will be per-
formed on the change from the inactive state to an active state. The tem-
perature applies to pH measurements.
3.2.2.50. UserMeth.FreeMem
read only
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g.
"4928".
3.2.2.51. UserMeth.Recall
$G
UserMeth.Recall.Name
up to 8 ASCII characters
UserMeth.Store
$G
UserMeth.Store.Name
up to 8 ASCII characters
UserMeth.Delete
$G
UserMeth.Delete.Name
up to 8 ASCII characters
UserMeth.DelAll
$G
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after
entering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.52. UserMeth.List.1.Name
read only
UserMeth.List.1.Mode
read only
UserMeth.List.1.Quantity
read only
UserMeth.List.1.Bytes
read only
UserMeth.List.1.Checksum
read only
for each method