Metrohm 785 DMP Titrino User Manual

Page 101

3.2. Remote control commands

785 DMP Titrino

In place of "RSX", a result name may be entered (.TextRS). This name is out-
putted in the report full, short, scalc full and scalc srt. It is used for the result
and the corresponding mean value.
The limit control for results can also be activated. If a result is out of limit, a
message appears in the result report, E196 is sent, and output line L13 can
be set.

3.2.2.6.

Mode.Def.SiloCalc.Assign.C24

RSX, EPX, CXX

Mode.Def.SiloCalc.Assign.C25

RSX, EPX, CXX

Mode.Def.SiloCalc.MatchId

id1, id1&2, all, OFF

.Assign.C2X: Assignment to store results in the silo as C2X.
.MatchId:

Indication which sample identification(s) have to match so that
the results can be combined.

3.2.2.7.

Mode.Def.ComVar.C30

RSX, MNX, EPX, CXX

Mode.Def.ComVar.C31
etc., up to .C39

Assignment of common variables.
The values of the common variables are to be found in &Config.ComVar. They
can be viewed and entered there, see 3.2.2.82.

3.2.2.8.

Mode.Def.Report.Assign1
Mode.Def.Report.Assign2
DET: full, short, mplist, curve, derive comb, scalc full, scalc srt,

calc, param, calib, ff

MET, SET, MEAS: full, short, mplist, curve, scalc full, scalc srt,

calc, param, calib, ff

CAL: full, short, scalc full, scalc srt, calc, param, calib, ff
TIP: full, short, scalc full, scalc srt, calc, param, ff

Definition of the report sequence, which is outputted automatically at the end
of the determination. Entries of more than one block have to be separated
with ";".
.Assign1: Output to COM1 of the Titrino. Identical for COM2.

3.2.2.9.

Mode.Def.Mean.1.Assign

RS1, RSX, EPX, CXX

Mode.Def.Mean.2.Assign
etc., up to .9

Assignment of the statistics calculations. Valid assignments are a require-
ment for statistics calculations. In addition, the statistics calculation must be
switched on, see 3.2.2.23. Rules for statistics calculations see page 41.

3.2.2.10. Mode.Def.TempVar.C70

RSX, EPX, CXX

etc. up to .C79

Assignment of temporary variables in a submethod for calculations in TIP.

3.2.2.11. Mode.CFmla