Metrohm 785 DMP Titrino - Manual (Page 120)

3.2 Remote control commands
785 DMP Titrino
117
The cycle number is set to 0 on switching on the instrument, on every start
and for QuickMeas. It is incremented as long as the instrument remains
switched on.
3.2.2.102. Info.ActualInfo.Assembly.Counter.V read only
Info.ActualInfo.Assembly.Counter.Clear $G
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G,
the volume counter is set to zero.
3.2.2.103. Info.ActualInfo.Assembly.Meas read only
$Q sends the current measured value from the assembly.
3.2.2.104. Info.ActualInfo.Titrator.CyclNo read only
Info.ActualInfo.Titrator.V read only
Info.ActualInfo.Titrator.Meas read only
Info.ActualInfo.Titrator.dVdt read only
Info.ActualInfo.Titrator.dMeasdt read only
Info.ActualInfo.Titrator.dMeasdV read only
Info.ActualInfo.Titrator.ERC read only
Info.ActualInfo.Titrator.T read only
$Q sends the current values in the following formats:
DET MET SET MEAS CAL
CyclNo 127 127 127 127 127
V(ml) 1.2345 1.2345 1.2345 - -
Meas:
pH
U, Ipol (mV)
Upol (uA)
T (°C) 3.345
-345.6
-12.5
- 3.345
-345.6
-12.5
- 3.6(mV)
-345.6
-12.5
- 3.345
-345.6
-12.5
25.0 3.345
-
-
-
dVdt (ul/s) - - 2.5142 - -
dMeasdt
pH,U,Ipol mV/s
Upol (uA/s)
T (°C/s) 0.7957
0.7957
- 0.7957
0.7957
- 0.7957
0.7957
- 0.7957
0.7957
0.7957 0.7957
-
-
dMeasdV (mV/ul) - - 10.6326 - -
ERC 34 - - - -
T (°C) 25.9 25.9 - 25.9 -
NV: Not Valid. If in the signal drift is OFF in modes MEAS and CAL, the signal
drift is NV.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.108). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.105. Info.ActualInfo.MeasPt.Index read only
Info.ActualInfo.MeasPt.X read only