Metrohm 785 DMP Titrino - Manual (Page 111)

3.2. Remote control commands
785 DMP Titrino
108
3.2.2.58. MemoryCard.Reload $G
MemoryCard.Reload.Name up to 10 ASCII characters
Reload a backup from the memory card into the internal memory. The action
is carried out if "$G" is transmitted to the corresponding node.
Do not use blank characters before and after name!
3.2.2.59. MemoryCard.Format $G
MemoryCard.CardLabel.Name up to 8 ASCII characters
Format the memory card. The action is carried out if "$G" is transmitted to the
corresponding node.
Do not use blank characters before and after name!
3.2.2.60. MemoryCard.FreeMem read only
Free memory on the card. $Q sends number of free bytes, e.g. "4928".
3.2.2.61. MemoryCard.BatteryChange $G
MemoryCard.BatteryChange.Date YYYY-MM-DD
Date for changing battery. The date will be set with "$G".
3.2.2.62. MemoryCard.List.Card.1.Name read only
MemoryCard.List.Card.1.Bytes read only
for each directory
List of all directories on the memory card with the following information:
.Name:
Name of the directory
.Bytes: Number of bytes used by the directory
3.2.2.63. MemoryCard.List.ActDir.1.Name read only
MemoryCard.List.ActDir.1.Mode read only
MemoryCard.List.ActDir.1.Quantity read only
MemoryCard.List.ActDir.1.Bytes read only
MemoryCard.List.ActDir.1.Checksum read only
for each method
List of all methods of the current card directory with the following information:
.Name:
Name of the method
.Mode: Mode
.Quantity: Measured quantity
.Bytes:
Number of bytes used by the method
.Checksum: Checksum of the method, see 3.2.2.94.
3.2.2.64. Config.Monitoring.Validation.Status ON, OFF
Config.Monitoring.Validation.Interval 1...365...9999
Config.Monitoring.Validation.Counter 0...9999
Config.Monitoring.Validation.ClearCount $G
Monitoring of validation.
.Interval:
Time interval in days for validation.
.Counter: Time counter in days since last validation.
.ClearCount: Clears the above counter.