Metrohm 785 DMP Titrino User Manual
Page 124
3.2 Remote control commands
785 DMP Titrino
121
The Titrino automatically reports when a value has been confirmed with
&SmplData.OFFSilo.Id1"Trace"
The beginning of the message is marked by a space (ASCII 32).
3.2.2.119. Setup.Lock.Keyboard
ON, OFF
Setup.Lock.Config
ON, OFF
Setup.Lock.Parameter
ON, OFF
Setup.Lock.SmplData
ON, OFF
Setup.Lock.UserMeth.Recall
ON, OFF
Setup.Lock.UserMeth.Store
ON, OFF
Setup.Lock.UserMeth.Delete
ON, OFF
Setup.Lock.Display
ON, OFF
ON means disable the corresponding function:
.Keyboard: Disable all keys of the Titrinos
.Config:
Disable the
.Parameter:Disable the
.SmplData: Disable the
.UserMeth.Recall: Disable "recall" in
.UserMeth.Store: Disable "store" in
.UserMeth.Delete: Disable "delete" in
.Display: Disable the display, i.e. it will not be written to by the device pro-
gram of the Titrino and can be operated from the computer.
3.2.2.120. Setup.Mode.StartWait
ON, OFF
Setup.Mode.FinWait
ON, OFF
Holding points in the method sequence. If they are "ON", the sequence stops
until "OFF" is sent. Switching the instrument on sets both nodes to OFF:
.StartWait: Holding point right after starting a method or submethod in TIP
(holding point after AutoInfo !".T.GC").
.FinWait:
Holding point at the end a method or submethod in TIP (holding
point after AutoInfo !".T.F").
3.2.2.121. Setup.SendMeas.SendStatus
ON, OFF
Setup.SendMeas.Interval
0.08...4...16200, MPList
.SendStatus: ON means the automatic transmission of measured values (see
3.2.2.123 and 3.2.2.124) in the inputted interval is active.
.Interval:
Time interval (in s) for the automatic transmission of associated
measured values defined under points 3.2.2.123 and 3.2.2.124.
The inputted value is rounded off to a multiple of 0.08. The small-
est possible time interval depends on the number of measured
values which have to be sent, on the baud rate, on the load on the
interface and on the type of device connection. With "MPList" the
measured values are sent at the time of their entry into the meas-
ured point list.
The automatic transmission is switched on/off with 'SendStatus'.
3.2.2.122. Setup.SendMeas.Select
Assembly, Titrator