Metrohm 785 DMP Titrino User Manual
Page 126
3.2 Remote control commands
785 DMP Titrino
123
Setup.AutoInfo.T.O
ON, OFF
Setup.AutoInfo.T.N
ON, OFF
Setup.AutoInfo.T.Re
ON, OFF
Setup.AutoInfo.T.Si
ON, OFF
Setup.AutoInfo.T.M
ON, OFF
Setup.AutoInfo.T.EP
ON, OFF
Setup.AutoInfo.T.RC
ON, OFF
Setup.AutoInfo.C.B1
ON, OFF
Setup.AutoInfo.C.R1
ON, OFF
Setup.AutoInfo.C.B2
ON, OFF
Setup.AutoInfo.C.R2
ON, OFF
Setup.AutoInfo.I
ON, OFF
Setup.AutoInfo.O
ON, OFF
ON means that the Titrino reports automatically the moment the correspond-
ing change occurs.
.Status:
Global switch for all set AutoInfo.
.P
PowerOn: Simulation of power on (3.2.2.127). Not from mains.
Messages from node .T, Titrator:
.T.R
Ready: Status 'Ready' has been reached.
.T.G
Go: Instrument has been started.
.T.GC
GoCommand: Instrument (or submethod in TIP) has received a go
command.
.T.S
Stop: Status 'Stop' has been reached.
.T.B
Begin of sequence (or submethod).
.T.F
Final: End of determination (or submethod), the final steps will be
carried out.
.T.E
Error. Message together with error number, see page 73ff.
.T.H
Hold: Status 'Hold' has been reached.
.T.C
Continue: Continue after hold.
.T.O
Conditioning OK: EP reached (in SET with conditioning).
.T.N
Conditioning Not OK: EP not reached (in SET with conditioning).
.T.Re
Request: In the inquiry of an identification or the sample size after
start of titration.
.T.Si
SiloEmpty: Silo empty, i.e. the last line has been removed from
the silo memory.
.T.M
MeasList: Entry in the measuring point list (with DET, MET, SET,
MEAS).
.T.EP
EPList: Entry into EP list (with DET, MET, SET)
.T.RC
Results have been recalculated.
Messages from node .C, Comport:
.C.B1
COM1: A report is outputted on COM1. During this time, COM2
will be blocked. COM2 is generally blocked, if COM1 is busy.
.C.R1
COM1 is ready again. (Comes also when you
.C.B2, .R2 Identical for COM2.
Messages for changings in the I/O lines. If the changings are made simulta-
neously, there is 1 message. Pulses receive 2 messages: one message each
for line active and inactive.
.I
Input: Change of an input line.
.O
Output: Change of an output line (except 7, pin 2, for recorder
pulses).
If a change occurs that requires a message, the Titrino sends space (ASCII
32) and ! as an introducer. This is followed by the name of the device (see