Rockwell Automation Liqui-Flo V2.0 AC Drive - Manual (Page 117)

Rockwell Automation Publication D2-3518-3 - May 2013 117
Chapter 9
Resets all inverter parameter values to defaults. Option 1 resets the inverter to
factory settings. Options 2 and 3 resets the inverter to alternate voltage and
current rating. After a restore defaults operation is performed, the value of this
parameter returns to 0 for Ready.
Loads a previously saved set of inverter parameter values from a selected user set
location in drive non-volatile memory to active drive memory.
An F-Key on the OIM can be configured for this function. See Appendix B .
After a Load From User Set operation is performed, the value of this parameter
returns to 0 for Ready.
Saves the inverter parameter values in active drive memory to a user set in drive
non-volatile memory.
An F-Key on the OIM can be configured for this function. See Appendix B .
After a Save To User Set operation is performed, the value of this parameter
returns to 0 for Ready.
197 Reset To Defalts
Range: 0 = Ready
1 = Factory
2 = Low Voltage
3 = High Voltage
Default: 0 = Ready
Access: 0 Path: Utility > Drive Memory
See also:
198 Load Frm Usr Set
Range: 0 = Ready
1 = User Set 1
2 = User Set 2
3 = User Set 3
Default: 0 = Ready
Access: 0 Path: Utility > Drive Memory
See also: 199
199 Save To User Set
Range: 0 = Ready
1 = User Set 1
2 = User Set 2
3 = User Set 3
Default: 0 = Ready
Access: 0 Path: Utility > Drive Memory
See also: 198