Rockwell Automation Liqui-Flo V2.0 AC Drive - Manual (Page 109)

Rockwell Automation Publication D2-3518-3 - May 2013 109
Chapter 9
Derivative gain for the bus regulator. Used to control regulator overshoot.
This parameter is not used with LiquiFlo 2.0 AC drives.
Enables/disables the function which reconnects to a spinning motor at actual
RPM when a start command is issued.
Adjusts the responsiveness of the flying start function. Increasing the value in this
parameter increases the responsiveness of the flying start function.
165 Bus Reg Kd
Range: 0...10000
Default: 1000
Access: 1 Path: Dynamic Control > Stop/Brake Modes
See also:
168 Start At PowerUp
Range: 0 = Disabled
Default: 0 = Disabled
Access: 0 Path: Dynamic Control > Stop/Restart Modes
See also:
169 Flying Start En
Range: 0 = Disabled
1 = Enabled
Default: 0 = Disabled
Access: 1 Path: Dynamic Control > Stop/Restart Modes
See also: 170
170 Flying Start Gain
Range: 20...32767 [1]
Default: 4000
Access: 1 Path: Dynamic Control > Restart Modes
See also: 169
174 Auto Rstrt Tries
Range: 0...9 [1]
Default: 0 (Disabled)
Access: 0 Path: Dynamic Control > Restart Modes
See also: 175
ATTENTION: Equipment damage and/or personal injury may result if
parameter 174 is used in an inappropriate application. Do not use this function
without considering applicable local, national, and international codes,
standards, regulations, or industry guidelines.