Rockwell Automation 6000 PowerFlex Medium Voltage Variable Frequency Drive Commissioning Manual - Manual (Page 7)

Rockwell Automation Publication 6000-IN007A-EN-P - October 2014 7
Preface
Introduction This document provides procedural information for commissioning
PowerFlex 6000 medium voltage drives.
Who Should Use This Manual This manual is intended for Rockwell Automation Field Service Engineers with
Medium Voltage Drive factory training and field experience commissioning
medium voltage solid-state variable speed drive equipment.
What Is Not in This Manual This manual is generic and does not include project-specific or drive-specific
information. Contact the Start-up Project Manager for required project-specific
or drive-specific information such as:
• Dimensional Drawings and Electrical Drawings generated for the
customer’s order.
• Spare parts lists compiled for the customer’s order.
• Drive-specific technical specifications.
• Pre-commissioning Checklist
• PLC program for standard, integral PLC
Required Supplemental
Information Dimensional Drawings and Electrical Drawings
Thoroughly review the project-specific Dimensional Drawings (DDs) and
Electrical Drawings (EDs) to understand the specific drive system being
commissioned, before performing any mechanical or electrical work.
Within these drawings is detailed information which is important to understand
for the commissioning and installation of the equipment.
Table 1 - Electrical Drawings
Contactor Locations (electrically)
Drive Topology
General Notes
Minimum Power Cable Insulation Ratings
Component Designations
Customer Power and Control Wiring Locations (electrically)
Control and Medium Voltage Power Ratings
Fuse Locations (electrically)
Table 2 - Dimensional Drawings
Control and Medium Voltage Power Ratings
Drive Options
Motor Ratings
Drive Power Component Selection Ratings