Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 338)

Publication 900-UM007D-EN-E - January 2011
5-110 Parameter Functions & Definitions
Figure 5.14
Protocol Setting
Communications Unit No.
Communications Baud Rate
Communications Data Length
Communications Stop Bits
Communications Parity
Send Data Wait Time
Conditions of Use: The Communications function must be supported by the
controller.
Function: These parameters allow you to match the communications
specifications of the controller(s) with the personal computer which has the
appropriate configuration or communication software. If a 1:N connection is
being used (RS-485), ensure that the communications specifications for all
devices in the system are the same except for the unit number. Each device
needs an individual unit number for RS-485 communication.
25
100
C
1 Operation function group entered for software reset.
Initial Setting
Function Group Initial Setting
Function Group
Operation
Function Group
Started in automatic mode.
Power ON
Press the Key
for at least 1 second.
Press the Key
for less than 1 second.
Press the Key
for less than 1 second.
Press the Key for at least
1 second. The display will flash.
Press the Key
for at least 3 seconds.
Communications
Setting
Function Group
Control Stops 1
psel
u-no
bps
len
sbit
prty
sdwe