Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 250)

Publication 900-UM007D-EN-E - January 2011
5-22 Parameter Functions & Definitions
MV Monitor (Cooling)
Conditions of Use: The control method must be heating and cooling control.
The Manipulated Variable Display parameter must be configured to ON.
Function: This parameter is for monitoring the manipulated variable (cooling
output) during heating and cooling control.
Table 5.Z
• This parameter cannot be configured.
• During heating/cooling control the manipulated variable on the cooling
Control Output is monitored.
• The default is OFF and the manipulated variable is NOT displayed.
Related Parameters
• Standard or Heating and Cooling (Initial Setting function group, page
5-55)
• Manipulated Variable Display (Advanced Setting function group,
page 5-78)
Adjustment Function Group This function group is for executing AT (auto-tuning) or setting up the
controller.
This function group provides you with basic controller setup parameters for
PID (Proportional Band, Integral Time, Derivative Time) plus heating and
cooling control parameters.
Figure 5.4
Control Mode Monitoring Range Units
Heating and cooling 0.0…105.0 %
c-o
Control in Progress
Press the Key for
less than 1 second.
Operation
Function Group
Adjustment
Function Group