Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 236)

Publication 900-UM007D-EN-E - January 2011
5-8 Parameter Functions & Definitions
Note: When a temperature input (e.g., RTD) is selected, the decimal point
position depends on the currently selected sensor, and when an analog
input is selected, it depends on the Decimal Point parameter setting.
Related Parameters
Refer to the Initial Setting function group:
• Input Type (page 5-50)
• Set Point Upper-Limit, Set Point Lower-Limit (page 5-54)
PV/SP – Process Value/Set Point – No. 1 Display
PV/SP – Process Value/Set Point – No. 2 Display (900-TC8)
Function: The process value is displayed on the No. 1 display, and the set
point is displayed on the No. 2 display.
No. 3 Display (900-TC8)
The following table shows the contents of the No. 3 display, according to the
configuration of the PV/SP Display Screen Selection parameter.
Table 5.I
Parameter Monitoring Range Units
Process
Value Temperature: According to indication range for each sensor.
Analog: Scaling lower limit -5% FS to Scaling upper limit +5% FS EU
Table 5.J
Parameter Configurable Range Units
Set Point SP lower limit to SP upper limit EU
Table 5.K
Configured Value No. 3 Display Contents
0 Only the PV and SP are displayed. (The No. 3 display is not shown.)
1 PV/SP/Multi-Sp and PV/SP/MV are displayed in order.
2 PV/SP/MV and PV/SP/Multi-SP are displayed in order.
3 Only PV/SP/Multi-SP are displayed
4 PV/SP/MV are displayed