Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 234)

Publication 900-UM007D-EN-E - January 2011
5-6 Parameter Functions & Definitions
• Set this parameter to 0 when no password is to be configured.
Related Parameters
• Move to Protect function group (Protect function group, page 5-3)
Note: Protection cannot be cleared or changed without the password. Be
careful not to forget it.
Operation Function Group Use this function group when you want to carry out control operations on the
Bulletin 900-TC8, 900-TC16, and 900-TC32. You can configure/set alarm
values, monitor the manipulated variable (MV), and perform other operations
within this function group.
Note: This function group is displayed immediately after the power is turned
ON. To select other function groups, press the
key, or
simultaneously hold down the and the
M
key.
Figure 5.3
Table 5.G
Configuration Range Default
−1999…9999
0
Control in progress
Control stopped
Operation
Function Group
Initial Setting
Function Group
Control stops.
Communi-
cations
Setting
Function
Group
Adjustment
Function Group
Power ON
Press the
O Key less than 1 s.
Press the O Key
for at least 1 s.
Press the O Key for at
least 1 s; display will flash.
Press the O Key for at least 3 s.
Press the
O Key for less than 1 s.
25
100
C