Rockwell Automation 900-TC32 Digital Temperature Controllers, Series B - Manual (Page 273)

Publication 900-UM007D-EN-E - January 2011
Parameter Functions & Definitions 5-45
Monitor/Setting Item Level
(900-TC8) Monitor/setting items can be displayed by means of the PF function key when
the PF Setting parameter (Advanced Setting function group) is configured to
PFDP: Monitor/Setting Item.
Monitor/Setting Item Display 1 to 5
Conditions of Use: The PF Setting parameter must be configured to PFDP,
and the Monitor/Setting Item 1 to 5 parameters must NOT be set to OFF.
Function: When the PF Key is configured to display monitor/setting items,
pressing the PF Key will display in order the contents of the Monitor/Setting
Item 1 to 5 parameters. The contents of these parameters are shown in the
following table. For the setting (monitor) ranges, refer to the applicable
parameters.
Table 5.BA
Set
Value
Setting
Remarks
Monitor/Setting Symbol
0 Disabled ---
1 PV/SP/Multi-SP Can be set. (SP) ---
2 PV/SP/MP Can be set. (SP) ---
3 PV/SP / Soak time remain Can be set. (SP) ---
4 Proportional band (P) Can be set.
p
5 Integral time (I) Can be set. i
6 Derivative time (D) Can be set.
d
7 Alarm value 1 Can be set. al-1
8 Alarm value upper limit 1 Can be set.
al1h
9 Alarm value lower limit 1 Can be set. al1l
Power ON
Operation
Function Group
Adjustment
Function Group
Press the Key
for at least 1 second.
PF PF Key Key
Control in Progress
Monitor/Setting Item
Function Group