Rockwell Automation 284G ArmorStart - User Manual - Manual (Page 81)

1
Chapter
4
Bulletin 284G Programmable Parameters for
Sensorless Vector Controllers
This chapter describes each programmable parameter and its function for
Bulletin 284G Sensorless Vector Controllers.
Parameter Programming Each Distributed Motor Controller type will have a common set of
parameters followed by a set of parameters that pertain to the individual
starter type.
Refer to Chapter 5, DeviceNet™ Commissioning, for instructions in using
RSNetworx
™
for DeviceNet
™
to modify parameter settings.
Important: Resetting the Factory Default Values Parameter 47, Set to
Defaults, allows the installer to reset all parameter to the
factory default values. It also resets the MAC ID to its factory
default after DeviceNet Power is cycled if switches are set >63.
Important: Parameter setting changes downloaded to the ArmorStart®
take effect immediately, even during a running status.
Important: Parameter setting changes made in a configuration tool such as
RSNetworx for DeviceNet do not take effect in the ArmorStart
until the installer applies or downloads the new settings to the
device.