Rockwell Automation 284G ArmorStart - User Manual - Manual (Page 104)

4-24 Bulletin 284G Programmable Parameters for Sensorless Vector Controllers
Output Power
The output power present at T1, T2, and T3. Parameter Number 122
Access Rule GET
Data Type UINT
Group
Display Group
Units
Minimum Value 0.00
Maximum Value Drive rated power X 2
Default Value Read Only
Output Power Fctr
The angle in electrical degrees between motor voltage and current. Parameter Number 123
Access Rule GET
Data Type UINT
Group Display Group
Units 0.1
°
Minimum Value 0.0
°
Maximum Value 180.0
°
Default Value Read Only
Drive Temp
Present operating temperature of the drive power section. Parameter Number 124
Access Rule GET
Data Type UINT
Group Display Group
Units 1
°
C
Minimum Value 0
Maximum Value 120
Default Value Read Only
Counter Status
The current value of the counter when counter is enabled.
Parameter Number 125
Access Rule GET
Data Type UINT
Group Display Group
Units 1
Minimum Value 0
Maximum Value 9999
Default Value Read Only
Timer Status
The current value of the timer when timer is enabled. Parameter Number 126
Access Rule GET
Data Type UINT
Group Display Group
Units 0.1 sec
Minimum Value 0
Maximum Value 9999
Default Value Read Only