5 setting the multicast configuration, Setting the multicast configuration, Setting the multicast configuration ( 43) – Lenze E94AYCEO User Manual
Page 43: 6commissioning
6
Commissioning
6.3
Setting the IP configuration of the Servo Drive 9400
43
Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.3.5
Setting the multicast configuration
Several scanners ("Listen only" or "Input only" connections) can access multicast telegrams which
are sent by drives. Settings for multicast configuration have to be carried out as well in the
EtherNet/IP configuration software (z. B. »RSLogix 5000« from Rockwell).
By default, the communication module automatically generates the Multicast IP start address for I/
O data transfer. The standard TTL value for Multicast transfer is ’1’; the Multicast I/O data packages
are therefore distributed solely via the local network.
The following multicast codes are configurable:
Multicast IP Start Address
Multicast IP start addresses serve to send a message to the members of a certain group (i.e. possibly
to several nodes).
The multicast IP start address is set/changed in
In
/
the currently used multicast IP address of the drive is shown.
Note!
You can also explicitly set the multicast IP start address and the multicast TTL value. We
recommend, however, not to change the default settings in order to ensure a secure
multicast transmission.
Code
Description
Selection for multicast IP addressing via the instance attribute 9 (Mcast Config) in the
IP Interface Object (245 / 0xF5) ( 132)
• Value ’0’: The default algorithm is used.
• Value ’1’: The address stored in code
is used as multicast IP start
address.
Setting of the multicast TTL value for the validity time of data packets in the EtherNet/IP
network
(Instance attribute 8 (TTL Value) in the
TCP/IP Interface Object (245 / 0xF5) ( 132)
)
Used to set how many multicast IP addresses will be assigned.
(Instance attribute 9 (Num Mcast) in the
TCP/IP Interface Object (245 / 0xF5) ( 132)
)
Example: Display of the multicast IP address 239.64.2.224
Code
Value
239
64
2
224