Lenze E94AYCEO - Manual (Page 133)

14 Implemented CIP™ objects
14.2 EtherNet/IP objects
133
Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Instance attribute "Status" (attribute 1)
8 Get / Set TTL Value USINT TTL value ( C13019 / C14019 ) for EtherNet/IP
multicast data packets
(value range: 1 ... 255)
9 Get / Set Mcast Config: STRUCT of: Configuration of the multicast IP addressing
Alloc Control USINT Control word ( C13018 / C14018 ) for
addressing:
• 0: The multicast IP addresses are
generated with the standard assignment
algorithm.
• 1: The multicast IP addresses are assigned
via the values in "Num Mcast" and "Mcast
Start Addr" ( C13006 / C14006 )
• 2: Reserved
Reserved USINT 0 (0x0000)
Num Mcast UINT Total number of multicast IP addresses
assigned ( C13020 / C14020 )
Mcast Start Addr UDINT Active multicast IP start address ( C13016 /
C14016 )
10 Set SelectAcd BOOL Activation of address conflict detection (ACD,
C13846 / C14846 )
• 0: Disable ACD
• 1: Enable ACD
Changing this value requires a reset of the
device ("power off/on" or "type 0 reset").
11 Get / Set LastConflictDetected: STRUCT of: ACD diagnostics information about the last
occurred address conflict
AcdActivity USINT Status of the ACD algorithm when the last
address conflict occurred:
• 0: NoConflictDetected (default)
• 1: ProbeIpv4Address
• 2: OngoingDetection
• 3: SemiActiveProbe
RemoteMAC ARRAY of
USINT[6]
MAC address of the device with the last
address conflict
ArpPdu ARRAY of
USINT[28]
Reproduction of the ARP message with
information about the address conflict
 Structure of the ARP message
(attribute 11, "ArpPdu") ( 135)
Bits Name Description
0 ... 3 Interface Configuration
Status
• 0000: No TCP/IP configuration available (attribute 5)
• 0001: Valid TCP/IP configuration (attribute 5) via BOOTP, DHCP or
static/permanent storage
• 0010 ... 1111: Reserved
4 Mcast Pending This bit indicates a pending change of the multicast configuration in
attribute 9 (Mcast Config) and/or the TTL value ( C13019 / C14019 ). It is
set to ’1’ if either a multicast attribute or the TTL value is set.
The pending change will only take effect after a reset of the device
("power off/on" or "type 0 reset"). This bit is then reset to ’0’.
5 Interface Configuration
Pending
This bit indicates a pending change of the TCP/IP configuration in
attribute 5 (Interface Configuration). It is set to ’1’ if an attribute is set.
The pending change will only take effect after a reset of the device
("power off/on" or "type 0 reset").
Attribute
ID
Service Name Data type Value