BNC 1105 Universal Counter User Manual

Page 74

[:VOLTage]:FTIMe?

[:VOLTage]:PWIDth?

[:VOLTage]:NWIDth?

[:VOLTage]:INITerval?

[:VOLTage]:PTPeak?

[:VOLTage]:MAXimum?

[:VOLTage]:MINimum?

[:VOLTage]:CENTer?

[:VOLTage]:PHASe?

[:VOLTage]:DCYCle?

[:VOLTage]:PDUTycycle?

[:VOLTage]:TOTalize:TIMed?

The Commands INITiate and FETCh?
These two commands provide the lowest level of control of measurement
triggering and reading retrieval, but offer the most flexibility. After you
have configured the universal counter, use the command INITiate to
initiate the measurements. The results are sent to the internal memory
and stored until you are ready to read them.

FETCh[[:SCALar]:]?

For more information about , please refer to the above table.

The command FETCh? sends the data in the universal counter’s internal
memory to the output buffer where you can read them into your bus
controller.

:INITiate

:AUTO

:CONTinuous

[:IMMediate]

:FETCh

FETCh[:SCALar]

[:VOLTage]:FREQuency?

[:VOLTage]:FREQuency:RATio?

[:VOLTage]:PERiod?

[:VOLTage]:RISE:TIME?