BNC 1105 Universal Counter - Manual (Page 34)

34 34 34 34
Vmax (positive peak), Vmin (negative peak), Vc (average from
positive and negative peak) or Vpp (peak-to-peak).
c. Use the selections in the CH1 or CH2 to set the input conditions and
the trig Sens.
d. Use Show Status button to check the conditions of Input, Volt, Stats
and Limit.
e. Use Save&Recall button to save your settings (i.e., changes made in
steps a-d) if it’s needed (refer to Ch.4.9).
5. Press RUN button to make continuous measurements.
6. Press STOP/SINGLE button to stop current measurement or to make
single measurement.
Remote Interface Command
Use the following commands for making voltage peak measurement:
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage:MAXimum [1|2]”
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage:MINimum [1|2]”
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage: PTPeak [1|2]”
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage: CENter [1|2]”
Or
:CONFigure[:SCALar][:VOLTage]: MAXimum [(@1)|(@2)]
:CONFigure[:SCALar][:VOLTage]: MINimum [(@1)|(@2)]
:CONFigure[:SCALar][:VOLTage]:PTPeak [(@1)|(@2)]
:CONFigure[:SCALar][:VOLTage]: CENter [(@1)|(@2)]
:READ[[:SCALar][:VOLTage]:PTPeak]?
Or
:MEASure[:SCALar][:VOLTage]:MAXimum? [(@1)|(@2)]
:MEASure[:SCALar][:VOLTage]:MINimum? [(@1)|(@2)]
:MEASure[:SCALar][:VOLTage]:PTPeak? [(@1)|(@2)]
:MEASure[:SCALar][:VOLTage]:CENter? [(@1)|(@2)]