BNC 1105 Universal Counter - Manual (Page 69)

69 69 69 69
255. T he procedure is described as follows.
To set IP address, network mask or gateway
1. Press the softkey under DHCP to turn off DHCP.
2. Press the softkey under IP ADDR, NET MASK or GATEWAY.
3. Use the numeric keys to enter the value.
4. Press the softkey under ENTER to set the value or the softkey under
CANCEL to withdraw the changes.
To set up DNS
DNS (Domain Name Service) translates domain names into IP addresses.
If the DNS is being used, consult local network administrators with the
information about the host name, domain name and DNS server address.
A DNS server address is in the form of “n.n.n.n” as shown in the Figure
5-3 where n is an integer between 0 and 255.
Figure 5-3
To set the DNS server address: In the LAN menu, press the
softkey under DNS Setup and then the softkey under DNS server. Use
the numeric keys or the arrow keys to enter the DNS server address
(refer to Ch.4.2.1).
To set the host name: In the LAN menu, press the softkey under
Host Name. Use the numeric keys or the arrow keys to enter the Host
name (refer to Ch.4.2.1).
To set the domain name: In the LAN menu, press the softkey
under Domain Name. Use the numeric keys or the arrow keys to enter
the Domain name (refer to Ch.4.2.1).
5.4 Remote Interface Commands
One may instruct the MODEL 1105 to take measurement by using the
SCPI commands on a remote PC after the Counter and the PC are