BNC 1105 Universal Counter - Manual (Page 70)

70 70 70 70
connected and interface is properly configured as described in Ch.5.1.
The SCPI commands available for the MODEL 1105 are listed below for
quick reference. Refer to Appendix C for detailed command syntax and
description. For the new users to apply SCPI commands, please refer to
Appendix C.1 for the introductory material on SCPI.
※ Note: The following conventions are used in SCPI command listing.
Triangle brackets (<>) indicates that users must specify a value for the
enclosed parameter. The square brackets ([]) indicates that the
parameter is optional and can be omitted. A vertical bar (|) separates
several options for a parameter.
[,source_list]
[:VOLTage]:FREQuency [ [,]] [(@1)|(@2)|(@3)]
[:VOLTage]:FREQuency:RATio [ [,]]
[(@1),(@2)|(@3)]|
[(@2)|(@3),(@1)]
[:VOLTage]:PERiod [ [,]] [(@1)|(@2)|(@3)]
[:VOLTage]:RISE:TIME
[:VOLTage]:RTIMe
[ [,upper_reference]] [(@1)]
[:VOLTage]:FALL:TIME
[:VOLTage]:FTIMe
[ [,upper_reference]] [(@1)]
[:VOLTage]:PWIDth [] [(@1)]
[:VOLTage]:NWIDth [] [(@1)]
[:VOLTage]:INITerval [(@1),(@2)]
[:VOLTage]:PTPeak [(@1),(@2)]
[:VOLTage]:MAXimum [(@1),(@2)]
[:VOLTage]:MINimum [(@1),(@2)]
[:VOLTage]:CENTer [(@1),(@2)]
[:VOLTage]:PHASe [(@1),(@2)]
[:VOLTage]:DCYCle
[:VOLTage]:PDUTycycle
[] [(@1)]
[:VOLTage]:TOTalize:CONTinuous [(@1)]
[:VOLTage]:TOTalize:TIMed [] [(@1)]
Note: The command ※ [:VOLTage]:TOTalize:CONTinuous is allowed with
CONFigure only.