BNC 1105 Universal Counter User Manual
Page 26
26
26
26
26
To measure period
1. Connect your signal source to channel 1.
2. Press TIME&PERIOD button.
3. Press the softkey under Period to select period measurement
function.
4. Optional settings:
a. Use GATE&ExtArm button to set the gate time, resolution or arming
if needed (refer to Ch.4.3).
b. Use Scale&Offset button to set the scaling and offset parameters if
needed (refer to Ch.4.4).
c. Use Limit Modes button set the upper and lower limits if needed
(refer to Ch.4.5).
d. Use Stats button to set up the statistics function and limit filtering if
needed (refer to Ch.4.6).
e. Use the selections in the CH1 to set the input conditions and the trig
Sens.
f. Use Show Status button to check the conditions of Input, Volt, Stats
and Limit.
g. Use Save&Recall button to save your settings (i.e., changes made in
steps a-d) if needed (refer to Ch.4.9).
5. Press RUN button to make continuous measuremets.
6. Press STOP/SINGLE button to make single measurement or to stop
continuous measurements.
Remote Interface Command
Use the following commands for making period measurement:
[:SENSe]:FUNCtion[:ON] “[:][XNONe:]PERiod [1|2|3]”
Or
:CONFigure[:SCALar][:VOLTage]:PERiod [(@1)|(@2)|(@3)]
:READ[[:SCALar][:VOLTage]:PERiod]?
Or
:MEASure[:SCALar][:VOLTage]:PERiod? [(@1)|(@2)|(@3)]