BNC 1105 Universal Counter - Manual (Page 130)

130 130 130 130
:MEASure[:SCALar][:VOLTage]:FALL:TIME?
[ [,upper_reference>]][,(@1)]
Sets the measurement arming to “auto” and measures Fall Time with the specified
parameters.
The and are used to specify the lower and upper
points on the falling edge of the input signal. They can be specified as either a percentage
or an absolute voltage.
The and are used to configure the trigger setting.
When they are in percentage or defaults, auto-trigger is enabled and trigger level is the
specified value. When they are specified in voltage, auto-trigger is disabled and the
trigger level is the specified value.
default 10 pct
Percent range 0 to 100 pct
Percent resolution 10%
Voltage range -5.125V to 5.125V for ×1 attenuation
-51.25V to 51,25V for ×10 attenuation
Voltage resolution
0.0025V for ×1 attenuation
0.025V for ×10 attenuation
default 90 pct
Percent range 0 to 100 pct
Percent resolution 10%
Voltage range -5.125V to 5.125V for ×1 attenuation
-51.25V to 51,25V for ×10 attenuation
Voltage resolution
0.0025V for ×1 attenuation
0.025V for ×10 attenuation
default (@1)
range (@1)
:MEASure[:SCALar][:VOLTage]:RISE:TIME?
[ [,upper_reference>]][,(@1)]
Sets the measurement arming to “auto” and measures Rise Time with the specified
parameters.
The and are used to specify the lower and upper
points on the falling edge of the input signal. They can be specified as either a percentage
or an absolute voltage.
The and are used to configure the trigger setting.
When they are in percentage or defaults, auto-trigger is enabled and trigger level is the